Guitar for beginnersLesson 3 of 3
Your first two chords: Em and Am
10 min read
How to read a chord diagram, play clean Em and Am chords, strum four beats with a metronome and change chords without stopping.
A chord is several notes sounding together. Em (E minor) and Am (A minor) are the easiest chords to start with: they need only two or three fingers, and the two shapes are so similar that changing between them is quick. Add a few more chords and you can play a lot of well-known songs.
Reading a chord diagram
A chord diagram shows the neck standing upright, seen from the front:
- The six vertical lines are the strings: string 6 (low E) on the left, string 1 (high e) on the right.
- The horizontal lines are frets; the thick bar at the top is the nut.
- A filled dot is where you press, and the number in it is the finger: 1 index, 2 middle, 3 ring, 4 little.
- An empty circle above the nut is an open string (played, not pressed); an × is a string you don't play.
The Em chord
- Finger 2 presses string 5, fret 2.
- Finger 3 presses string 4, fret 2, right below finger 2.
- Strum all six strings from string 6 down to string 1.
The Am chord
- Finger 1 presses string 2, fret 1.
- Finger 2 presses string 4, fret 2.
- Finger 3 presses string 3, fret 2.
- Strum from string 5 down, skipping string 6.
Check every string
Hold the chord and pick one string at a time, slowly. A string that buzzes or sounds dead usually means:
- A finger is lying flat and touching the next string. Curve it more and press with the tip.
- The finger is far from the fret. Move it right behind the fret bar on the body side.
- Not enough pressure. Press a little firmer, but don't squeeze the neck with your thumb.
Four-beat strumming
Hold a pick loosely (or use the nail of your index finger) and strum down evenly across the strings, once per beat. Count "one, two, three, four" out loud and strum on each count.
MetronomeSet 60 BPM, 4 beats per bar. Every click is one down-strum.
Once it's even, play 4 beats of Em, then 4 beats of Am, and repeat. The goal is to change chords without breaking the beat: if you're not ready in time, strum the open strings on the last beat and keep going; experienced players do exactly that.
Practice15 min
- Hold Em and pick each string until all six ring clearly. Do the same with Am (five strings).
- Without strumming: change Em → Am → Em 20 times, watching your hand so fingers 2 and 3 move as one block.
- Start the metronome at 60 BPM and strum 4 beats of Em, then 4 beats of Am, for 2 minutes straight.
- When the beat no longer breaks, try 2 beats per chord, then go up to 70 BPM.
Well done: you can play two chords and change between them in time. The next lessons (being written) add C, G, D and your first strumming patterns for accompanying songs.
Done with this lesson?
Mark it so the course remembers where you are. Progress is only saved in this browser.